This is a very high quality end mill for cutting plastics, wood and aluminum. Will create a flat bottom surface Cut Diameter - 1/4 inch or 6.35mm Shank diameter - 1/4 inch or 6.35mm This is a very high quality end mill intended to cut plastic, aluminum, wood and solid surface and is Onsrud's super 'O' geometry. We use this end mill exclusively to cut our MDO parts and does a great job. The tool is very quiet, with their premium micro grain carbide there is superior wear resistance and strength. The top has a special geometry to better bottom finish and also works well for plunging into materials. Soft Wood, Hard Wood, MDF (Medium Density Fiberboard), Soft Plywood, Hard Plywood: Chip load: .004 to .006 Suggested Low End Feed Rate: 72 IPM Suggested High End Feed Rate: 108 IPM Soft Plastic, : Chip Load: .008 to .012 Suggested Low End Feed Rate: 144 IPM Suggested High End Feed Rate: 216 IPM Hard Plastic: Chip Load: .010 to .012 Suggested Low End Feed Rate: 180 IPM Suggested High End Feed Rate: 216 IPM Sheet Aluminum (16,000 RPM): Chip Load: .003 to .006 Suggested Low End Feed Rate: 48 IPM Suggested High End Feed Rate: 96 IPM All Feed Rates are based on 18,000 Spindle RPM except for the sheet aluminum.